一种简单而有效的防止高温光谱实验中显微物镜温度过高的装置：空气吹扫装置

doi:10.3964/j.issn.1000-0593(2016)09-2742-07

Abstract
References
Related Citation (15)

Download: PDF (2035 KB)
Export: BibTeX | EndNote (RIS)

Abstract The interior of the Earth is a high temperature and high pressure environment. High temperatures cause important changes in the physical and chemical properties of minerals. An increase in temperature leads to significant changes in the molecular and lattice vibrations, elasticity, and seismic velocity of minerals. The high temperature vibrational spectroscopy (infrared and Raman) used to study these changes can provide highly significant understanding of the Earth’s interior. During high temperature spectroscopy, the heating device that is used to heat the sample can work at a very high temperature (e.g., 1 500 ℃) because it has a cooling device surrounding it that is used to prevent the temperature of its environments from getting too high. However, radiation from its heating elements is intense and this will shine on and heat the objective lens of the focusing system for the spectroscopic light source, and this would result in damage to the lens. Thus, to avoid damage to the objective lens, an upper limit is placed on the heater temperature. The significance of this work is that it presents a method to exceed the present instrument’s temperature limit so that we can perform in situ spectroscopy on samples at higher temperatures. This work extended the temperature limit for the sample to a higher temperature by using an air blower around the objective lens to create a gas flow around it. The gas flow serves to remove heat from the objective lens by forced convection and its turbulent flow also served to increase the rate of heat transport from the lens to the moving gas stream, which together prevented overheating of the objective lens. Our results have shown that although this device is simple, it was highly effective: for a sample temperature of 1 000 ℃, the objective lens temperature was reduced from ～235 to ～68 ℃. Using this device, we performed in situ high temperature Raman spectroscopy of forsterite up to a sample temperature of 1 300 ℃. The results agreed well with previous studies and demonstrated that with our simple air blower device, we can perform in situ high temperature spectroscopy up to 1 300 ℃ without damaging the objective lens and without expensive components like a high temperature composite objective lens or a long focus objective lens.

Key words：Air blower device;Spectroscopy;High temperature;Olivine

Received: 2015-04-06 Accepted: 2015-08-12

ZTFLH:

TH742

Corresponding Authors: LIU Xi E-mail: xi.liu@pku.edu.cn

Cite this article:

WANG Fei,LIU Xi,Lü Ming-da, et al. A Simple but Effective Device to Avoid Objective Lens Overheating: An Air Blower Device [J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2016, 36(09): 2742-2748.

URL:

https://www.gpxygpfx.com/EN/10.3964/j.issn.1000-0593(2016)09-2742-07 OR https://www.gpxygpfx.com/EN/Y2016/V36/I09/2742

[1] McKenzie D, Bickle M J. Journal of Petrology, 1988, 29(3): 625.
[2] Ito E, Katsura T. Geophysical Research Letters, 1989, 16(5): 425.
[3] Boehler R. Annual Review of Earth and Planetary Sciences, 1996, 24(1): 15.
[4] Gillet P, Richet P, Guyot F, et al. Journal of Geophysical Research, 1991, 96(B7): 11805.
[5] WANG Fei, LIU Xi, ZHENG Hai-fei, et al(王霏，刘曦，郑海飞，等). Acta. Petrolei. Sin.(岩石学报), 2015, 31(7): 1891.
[6] Waples D W, Waples J S. Natural Resources Research, 2004, 13(2): 123.
[7] Yong W, Dachs E, Withers A C, et al. Physics and Chemistry of Minerals, 2006, 33(3): 167.
[8] Chang L, Liu X, Liu H, et al. Physics and Chemistry of Minerals, 2013, 40(7): 563.
[9] Fei Y. Mineral Physics and Crystallography: a HandBook of Physical Constants. AGU Reference Shelf, No 2. 1995. 29.
[10] Katsura T, Yokoshi S, Song M, et al. Journal of Geophysical Research, 2004, 109(B12): 209.
[11] Hu X, Liu X, He Q, et al. Mineralogical Magazine, 2011, 75(2): 363.
[12] Stixrude L, Lithgow-Bertelloni C. Geophysical Journal International, 2005, 162(2): 610.
[13] Fan D, Zhou W, Liu C, et al. Journal of Materials Science, 2008, 43(16): 5546.
[14] Li B. American Mineralogist, 2003, 88(8-9): 1312.
[15] Higo Y, Inoue T, Irifune T, et al. Physics of the Earth and Planetary Interiors, 2008, 166(3): 167.
[16] O’Neill H St C, Redfern S A T, Kesson S, et al. American Mineralogist, 2003, 88(5-6): 860.
[17] Yang X, Keppler H. American Mineralogist, 2011, 96(2-3): 451.
[18] Yang Y, Xia Q, Feng M, et al. Physics and Chemistry of Minerals, 2012, 39(5): 413.
[19] McMillan P F. Microscopic to Macroscopic: Atomic Environments to Mineral Thermodynamics. Washington DC: Mineralogical Society of America，1985, vol. 14. 9.
[20] Durben D J, Wolf G H. American Mineralogist, 1992, 77(7-8): 890.
[21] Kieffer S W. Reviews of Geophysics and Space Physics, 1979a, 17(1): 1.
[22] Kieffer S W. Reviews of Geophysics and Space Physics, 1979b, 17(1): 20.
[23] Kieffer S W. Reviews of Geophysics and Space Physics, 1979c, 17(1): 35.
[24] Kojitani H, Oohata M, Inoue T, et al. American Mineralogist, 2012, 97(8-9): 1314.
[25] Fujimori H, Koatsu H, Loku K. Physical Review B, 2002, 66(6): 64306.
[26] Seward G. Optical Design of Microscopes. Washington DC: Society of Photo-Optical Instrumentation Engineers, 2010, 100, 169.
[27] Liu X, Chen J, Tang J, et al. High Pressure Research, 2012, 32(2): 239.
[28] HE Qiang, TANG Jun-jie, WANG Fei, et al(何强，唐俊杰，王霏，等). Chinese Journal of High Pressure Physics(高压物理学报), 2014, 28(2): 145.
[29] Liu X, O’Neill H St C, Berry A J. Journal of Petrology, 2006, 47(2): 409.
[30] Ringwood A E. Composition and Petrology of the Earth’s Mantle. New York: McGraw-Hill, 1975. 1.
[31] Kolesov B A, Geiger C A. Physics and Chemistry of Minerals, 2004, 31(3): 142.
[32] YAN Shi-yong, ZHOU Yao-qi, CHEN Yong(颜世永，周瑶琪，陈勇). The Journal of Light Scattering(光散射学报), 2004, 16(004): 325.
[33] MA Yan-mei, CUI Qi-liang, ZHOU Qiang, et al(马艳梅, 崔启亮, 周强, 等). Journal of Jilin University(吉林大学学报), 2006, 36(3): 342.