光谱学与光谱分析 |
|
|
|
|
|
Temperature Measurement of CH4/Air Premix Flat Flame Based on the Absorption Spectroscopy Technology of UV Tunable Laser |
YU Xin1,2, YANG Chao-bo1,2*, PENG Jiang-bo1,2, MA Yu-fei1, 2, 3, LI Xiao-hui1,2, ZHANG Ya-li1,2 |
1. Institute of Opto-Electronics, Harbin Institute of Technology, Harbin 150001, China 2. State Key Laboratory of Tunable Laser Absorption Spectroscopy Technology, Harbin Institute of Technology, Harbin 150001,China 3. Post-Doctoral Mobile Station of Power Engineering and Engineering Thermophysics, School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China |
|
|
Abstract The physics of combusting flows consists of a complex interaction between chemical reactions, fluid mechanics and radiation. Temperature is one of the most important parameters for the processes. Laser-based imaging techniques are frequently used to assess temperature information from reactive systems without perturbing the system under study. To verify the feasibility of the temperature measurement of UV tunable absorption spectroscopy technology the methane/air premix flat flame was selected as the target of test because of the combustion stability of this kind of flame. Before the temperature measurement the distribution of OH radical in the premix flat flame under different operating conditions were obtained by using planar laser induced fluorescence (PLIF). At the low equivalence ratio the OH radicals distribute uniformly in the flame for the adequate oxygen in the premix gas. The condition with uniform distribution of OH in the flame was selected for the UV tunable absorption spectroscopy measurement. For the selection of absorption lines of the measurement the spectrum of OH A-X(0,0) band have been simulated by LIFBASE. Considering the slope sensitivity and SNR of the test the transitions P1(2) and Q1(8) were suitable for the temperature measurement of the flame. A dye laser pumped by a frequency doubled Nd:YAG laser was used to generated the UV laser. The dye laser was operated with the mixed dye of DCM and PM580 for high conversion efficiency at 310 nm. To investigate the transitions of Q1(8) and P1(2) of OH A-X(0,0) the laser was tuned from 309.225~309.255 and 308.625~308.655 nm separately with the step of 0.4 pm, 30 pulses were recorded at each step. The laser pulses reflected by the beam splitter were collected by detector A, and the pulses passed the flame were collected by detector B. The signal of these two detectors were recorded by the oscilloscope and acquired by the computer automatically. The line shape of these transitions can be obtained after fitting the experimental data with the Voigt function. The integral ratio between the fitting results of these two lines was calculated. Then temperature of the flame could be deduced by the integral ratio. The temperatures of different positions above the surface of burner and varied heights of the flame center were obtained by measuring the integrated absorption ratio of these two transitions. The test results of this method are compared with the report in reference, in which temperature of the burner with the same structure was measured by other ways. The results of these two tests agree well. It shows that this method has the potential to be a calibration for the two-dimension thermometry in flame such as two-line PLIF.
|
Received: 2014-12-17
Accepted: 2015-04-25
|
|
Corresponding Authors:
YANG Chao-bo
E-mail: qqycb@163.com
|
|
[1] Hanson K, Jeffries J B. 24th AIAA Aerodynamic Measurement Technology and Ground Testing Conference, 2004. 28. [2] Kohse-Hinghaus K, Barlow R S, Aldén M, et al. Proceedings of the Combustion Institute, 2005, 30(1): 89. [3] Mark G A. Measurement Science and Technology, 1998, 9(4): 545. [4] Hanson R K, Jeffries J B. 25th AIAA Aerodynamic Measurement Technology and Ground Testing Conference, 2006, 2: 871. [5] Brown M S, Barone D L, Barhorst T F, et al. AIAA Paper, 2010, 6989: 2010. [6] Roy S, Kinnius P J, Lucht R P, et al. Optics Communications, 2008, 281(2): 319. [7] Seitzman J M, Hanson R, DeBarber P, et al. Applied Optics, 1994, 33(18): 4000. [8] Devillers R, Bruneaux G, Schulz C. Applied Optics, 2008, 47(31): 5871. [9] Chang A Y, DiRosa M D, Davidson D F, et al. Applied Optics, 1991, 30(21): 3011. [10] Crosley J L D R. SRI International Report, 1999, 99-009. [11] Hartung G, Hult J, Kaminski C F. Measurement Science and Technology, 2006, 17(9): 2485. |
[1] |
BAI Xi-lin1, 2, PENG Yue1, 2, ZHANG Xue-dong1, 2, GE Jing1, 2*. Ultrafast Dynamics of CdSe/ZnS Quantum Dots and Quantum
Dot-Acceptor Molecular Complexes[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2024, 44(01): 56-61. |
[2] |
ZHENG Pei-chao, YIN Yi-tong, WANG Jin-mei*, ZHOU Chun-yan, ZHANG Li, ZENG Jin-rui, LÜ Qiang. Study on the Method of Detecting Phosphate Ions in Water Based on
Ultraviolet Absorption Spectrum Combined With SPA-ELM Algorithm[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2024, 44(01): 82-87. |
[3] |
LIU Jia, ZHENG Ya-long, WANG Cheng-bo, YIN Zuo-wei*, PAN Shao-kui. Spectra Characterization of Diaspore-Sapphire From Hotan, Xinjiang[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2024, 44(01): 176-180. |
[4] |
GU Yi-lu1, 2,PEI Jing-cheng1, 2*,ZHANG Yu-hui1, 2,YIN Xi-yan1, 2,YU Min-da1, 2, LAI Xiao-jing1, 2. Gemological and Spectral Characterization of Yellowish Green Apatite From Mexico[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2024, 44(01): 181-187. |
[5] |
ZHANG Ning-chao1, YE Xin1, LI Duo1, XIE Meng-qi1, WANG Peng1, LIU Fu-sheng2, CHAO Hong-xiao3*. Application of Combinatorial Optimization in Shock Temperature
Inversion[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(12): 3666-3673. |
[6] |
LIANG Ya-quan1, PENG Wu-di1, LIU Qi1, LIU Qiang2, CHEN Li1, CHEN Zhi-li1*. Analysis of Acetonitrile Pool Fire Combustion Field and Quantitative
Inversion Study of Its Characteristic Product Concentrations[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(12): 3690-3699. |
[7] |
LI Xiao-dian1, TANG Nian1, ZHANG Man-jun1, SUN Dong-wei1, HE Shu-kai2, WANG Xian-zhong2, 3, ZENG Xiao-zhe2*, WANG Xing-hui2, LIU Xi-ya2. Infrared Spectral Characteristics and Mixing Ratio Detection Method of a New Environmentally Friendly Insulating Gas C5-PFK[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(12): 3794-3801. |
[8] |
ZHENG Ni-na1, 2*, XIE Pin-hua1, QIN Min1, DUAN Jun1. Research on the Influence of Lamp Structure of the Combined LED Broadband Light Source on Differential Optical Absorption Spectrum
Retrieval and Its Removing Method[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(11): 3339-3346. |
[9] |
DUAN Ming-xuan1, LI Shi-chun1, 2*, LIU Jia-hui1, WANG Yi1, XIN Wen-hui1, 2, HUA Deng-xin1, 2*, GAO Fei1, 2. Detection of Benzene Concentration by Mid-Infrared Differential
Absorption Lidar[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(11): 3351-3359. |
[10] |
CHEN Heng-jie, FANG Wang, ZHANG Jia-wei. Accurate Semi-Empirical Potential Energy Function, Ro-Vibrational Spectrum and the Effect of Temperature and Pressure for 12C16O[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(11): 3380-3388. |
[11] |
FANG Zheng, WANG Han-bo. Measurement of Plastic Film Thickness Based on X-Ray Absorption
Spectrometry[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(11): 3461-3468. |
[12] |
HUANG Li, MA Rui-jun*, CHEN Yu*, CAI Xiang, YAN Zhen-feng, TANG Hao, LI Yan-fen. Experimental Study on Rapid Detection of Various Organophosphorus Pesticides in Water by UV-Vis Spectroscopy and Parallel Factor Analysis[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(11): 3452-3460. |
[13] |
WANG Wen-song1, PEI Chen-xi2, YANG Bin1*, WANG Zhi-xin2, QIANG Ke-jie2, WANG Ying1. Flame Temperature and Emissivity Distribution Measurement MethodBased on Multispectral Imaging Technology[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(11): 3644-3652. |
[14] |
YU Hao-zhang, WANG Fei-fan, ZHAO Jian-xun, WANG Sui-kai, HE Shou-jie*, LI Qing. Optical Characteristics of Trichel Pulse Discharge With Needle Plate
Electrode[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(10): 3041-3046. |
[15] |
WANG Peng1, GAO Yong-bao1*, KOU Shao-lei1, MEN Qian-ni1, ZHANG Min1, HE Tao1, YAO Wei2, GAO Rui1, GUO Wen-di1, LIU Chang-rui1. Multi-Objective Optimization of AAS Conditions for Determination of Gold Element Based on Gray Correlation Degree-RSM Model[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2023, 43(10): 3117-3124. |
|
|
|
|