结合FBG-FP的变压器局部放电光纤全方向传感研究

doi:10.3964/j.issn.1000-0593(2024)02-0510-09

Abstract
References
Related Citation (15)

Download: PDF (14273 KB)
Export: BibTeX | EndNote (RIS)

Abstract To achieve sensitive detection of partial discharge in transformers and avoid missing partial discharge signals, a fiber optic omnidirectional sensing method for partial discharge in transformer oil combined with FBG and FP cavity is proposed based on fiber Bragg grating (FBG) and Fabry-Perot cavity sensing principle. The partial discharge sensing principle of FBG and FP cavity is introduced. The ultrasonic waves generated by partial discharge will cause a shift in the FBG reflection spectrum and the FP cavity interference spectrum, and the detection of partial discharge can be achieved by demodulating the optical intensity through the spectral edge demodulation method. A partial discharge fiber optic omnidirectional sensor was developed. A rectangular probe with the size of 25 mm×25 mm×25 mm was fabricated by 3D printing technology. The hollow structure of the probe was used to insert a single-mode fiber to form an FP cavity. In addition, the four sides of the probe were used to form a diaphragm-type FBG sensing structure, which can receive ultrasonic signals in different directions. The acoustic sensing diaphragm was designed based on the frequency spectrum characteristics of partial discharge in transformer oil and the vibration model of the diaphragm in the liquid phase environment. Corning glass coated with high reflectivity dielectric film was selected as the FP cavity sensing diaphragm with a radius of 1.7 mm and a thickness of 0.165 mm, and its theoretical resonant frequency is 82 kHz. Monocrystalline silicon was selected as the FBG sensing diaphragm with the radius of 2.5 mm and the thickness of 0.1 mm, and its theoretical resonant frequency is 25.6 kHz. The fiber optic sensing system for partial discharge was built, and the performance test was conducted on the partial discharge fiber optic omnidirectional sensor. The resonant frequency of FBG sensing diaphragm in transformer oil is about 23 kHz, and that of FP cavity sensing diaphragm is 71.4 kHz as measured by the pencil-break experiment. The fiber optic omnidirectional sensor was compared with the piezoelectric transducer (PZT) to detect the same partial discharge signal. 83.8 pC of metal tip discharge can be detected by the FBG sensing part and 27.1 pC of metal tip discharge can be detected by the FP cavity sensing part. The partial discharge detection sensitivity of fiber optic omnidirectional sensors is higher than that of PZT. The directional response of the sensor was tested. Ordinary FP sensors have a limited range of highly sensitive detection and a detection blind area. The developed partial discharge fiber optic omnidirectional sensor has the FP cavity sensing and FBG sensing parts. The highly sensitive detection range of the FP cavity sensing part is complementary to that of the FBG sensing part. The sensor can achieve omnidirectional sensitive partial discharge detection and has good directional response performance.

Key words：Transformer; Partial discharge; Fiber Bragg Grating; Fabry-Perot cavity; Omnidirectional

Received: 2022-07-27 Accepted: 2023-02-13

ZTFLH:

TM407

Corresponding Authors: CHEN Wei-gen E-mail: weigench@cqu.edu.cn

Cite this article:

WU Ke-jie,CHEN Wei-gen,ZHANG Zhi-xian, et al. Study of Fiber Optic Omnidirectional Sensing for Partial Discharge in Transformers by Combining FBG and FP Cavity[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2024, 44(02): 510-518.

URL:

https://www.gpxygpfx.com/EN/10.3964/j.issn.1000-0593(2024)02-0510-09 OR https://www.gpxygpfx.com/EN/Y2024/V44/I02/510

[1] MA Guo-ming, ZHOU Hong-yang, LIU Yun-peng, et al(马国明，周宏扬，刘云鹏，等). High Voltage Engineering(高电压技术), 2020, 46(5): 1768.
[2] LI Jun-hao, HAN Xu-tao, LIU Ze-hui, et al(李军浩, 韩旭涛, 刘泽辉，等). High Voltage Engineering(高电压技术), 2015, 41(8): 2583.
[3] Wang Yanbo, Chang Dingge, Fan Yuhang, et al. IEEE Transactions on Dielectrics and Electrical Insulation, 2017, 24(6): 3647.
[4] Hashim A H M, Azis N, Jasni J, et al. IEEE Transactions on Dielectrics and Electrical Insulation, 2022, 29(2): 623.
[5] Harbaji M, Shaban K, El-Hag A. IEEE Transactions on Dielectrics and Electrical Insulation, 2015, 22(3): 1674.
[6] RAO Qiao-meng, ZHANG Qi, XIN Xiang-jun, et al(饶俏萌, 张琦, 忻向军，等). Acta Optica Sinica(光学学报), 2020, 40(13): 22.
[7] Vidakovic M, McCague C, Armakolas I, et al. Journal of Lightwave Technology, 2016, 34(19): 4473.
[8] Li Haoyong, Lv Jiaming, Li Delin, et al. Optics Express, 2020, 28(12): 18431.
[9] CHEN Wei-gen, ZHANG Zhi-xian, LI Jian, et al(陈伟根，张知先，李剑，等). Proceedings of the CSEE(中国电机工程学报), 2020, 40(S1): 323.
[10] MA Bin, XU Jian(马宾, 徐健). Spectroscopy and Spectral Analysis(光谱学与光谱分析), 2017, 37(7): 2273.
[11] ZHOU Hong-yang, MA Guo-ming, ZHANG Meng, et al(周宏扬, 马国明, 张猛，等). Proceedings of the CSEE(中国电机工程学报), 2019, 39(21): 6452.
[12] ZHOU Hong-yang, MA Guo-ming, ZHANG Meng, et al(周宏扬, 马国明, 张猛，等). Proceedings of the CSEE(中国电机工程学报), 2022, 42(21): 8016.
[13] CHENG Li-feng, ZHANG Wei-chao, ZHAO Hong, et al(程立丰, 张伟超, 赵洪，等). Guangdong Electric Power(广东电力), 2020, 33(9): 11.
[14] CHEN Qi-chao, ZHAO Hong, ZHANG Wei-chao(陈起超, 赵洪, 张伟超). Optics and Precision Engineering(光学精密工程), 2020, 28(7): 1471.
[15] Zhang Zhixian, Lei Jiali, Chen Weigen, et al. High Voltage, 2022, 7(2): 325.
[16] WANG Xue-kuai, ZHANG Wei-chao, ZHAO Hong, et al(王学会, 张伟超, 赵洪，等). Acta Optica Sinica(光学学报), 2018, 38(4): 88.
[17] Sikorski W. Sensors, 2019, 19(8): 1865.
[18] LI Sheng-peng, SU Yang, LI Ya-quan, et al(李胜朋，苏阳，李亚权，等). Electric Switchgear(电气开关), 2022, 60(1): 12.
[19] ZHANG Zhi-xian, LEI Jia-li, CHEN Wei-gen, et al(张知先, 雷嘉丽, 陈伟根，等). High Voltage Engineering(高电压技术), 2022, 48(1): 58.
[20] Zhang Zhixian, Chen Weigen, Wu Kejie, et al. IEEE Transactions on Dielectrics and Electrical Insulation, 2022, 29(5): 1701.