|
|
|
|
|
|
| Mechanism of Fluoride and Arsenic Removal by Ce/γ-Al2O3 Based on XRD and FTIR |
| ZHANG Hai-yang1, GAO Bai1, 2*, FAN Hua3 , SHEN Wei1, LIN Cong-ye1 |
1. State Key Laboratory Breeding Base of Nuclear Resources and Environment, East China University of Technology, Nanchang 330013, China
2. School of Water Resources and Environmental Engineering, East China University of Technology, Nanchang 330013, China
3. Energysaving and Environmental Protection and Occoupational Safety and Health Research Institute Base of China Academy of Railway Scinences，Beijing 100081, China |
|
|
|
|
Abstract The harm caused by fluoride and arsenic in drinking water to public health is a global environmental problem, especially for the high fluorine and arsenic areas without centralized water supply. Compared to other technologies, adsorption to a solid surface is a simple, economical and reliable method for removing arsenic from fluoride. Although the conventional porous adsorbent is stable and inexpensive, the general adsorption amount is not high, and it is difficult to meet the actual needs. Therefore, it is urgent to develop a porous adsorbent which is inexpensive, high-efficiency, and simple in operation flow. The most widely used γ-Al2O3 surface has more -OH, the contact liquid has electrical properties, mainly relying on the surface adsorption site to remove fluorine and arsenic, resulting in limited adsorption effect. After modification, the adsorption process of the adsorbent material is complicated, which has the advantages of surface physical adsorption and pore diffusion. Rare earth element (Ce) is the most abundant element in rare earth. It is widely used in catalysts and alloy additives. Its oxide has high adsorption capacity, but the process of preparing granular rare earth oxide is complicated, and it may cause shedding and metal dissolution during use. And other issues. In order to reduce the process and increase the adsorption capacity of the particulate material, the rare metal salt impregnation method is used to avoid the problems of high cost and low mass production caused by complicated process flow. In this study, the porous adsorption material of y-salt Ce(SO4)2 loaded γ-Al2O3 was prepared by the impregnation method, and the adsorption characteristics of aqueous solution were tested. The adsorption kinetic model and isotherm model were obtained by data fitting to obtain the adsorption process and maximum. The amount of adsorption provides the basis for the adsorption mechanism of Ce/γ-Al2O3. The SEM, XRD and FTIR of the adsorption sorbent performance characterization test qualitatively analyze the adsorption force of Ce/γ-Al2O3 in addition to fluorine and arsenic, providing Ce/γ-Al2O3 Reliable evidence of adsorption mechanism. The results show that the removal of arsenic by fluorine and arsenic in Ce/γ-Al2O3 is in line with the pseudo-secondary kinetics and the Langmuir model. The maximum adsorption capacity of arsenic removal by fluoride can reach 47.842 and 18.518 mg·g-1, respectively. The surface of Ce/γ-Al2O3 is smooth, the load is good, and the combination is stable. Ce(Ⅳ) is reduced to Ce(Ⅲ) to form a Ce—O—Al composite. The main body of Ce/γ-Al2O3 is amorphous, with a small amount of incompletely developed grain structure and stable surface hydroxyl groups. The combination of XRD and FTIR reflects the phase structure and functional group of Ce/γ-Al2O3, which can be used for the identification and analysis of Ce/γ-Al2O3, further verifying the adsorption test process and reflecting the adsorption test phenomenon. γ-Al2O3 is improved by cerium salt Ce(SO4)2 impregnation method, The existence of Al—O and Ce—O, the existence of incomplete grains and the change of crystal structure of surface pore structure are the main controlling factors for the increase of Ce/γ-Al2O3 adsorption.
|
|
Received: 2019-08-13
Accepted: 2019-12-20
|
|
|
|
Corresponding Authors:
GAO Bai
E-mail: gaobai@ecit.cn
|
|
[1] Ramli A, Farooq M. Materials Science Forum, 2017, 888: 491.
[2] DENG Gui-you, ZHOU Hang, CAO Wei, et al(邓贵友, 周 航, 曹 玮, 等). Chinese Journal of Environmental Engineering(环境工程学报), 2016, 10(8): 4251.
[3] WU Cheng-hui, CHEN Chang-an, GAO Xu-bo, et al(吴承慧, 陈长安, 高旭波, 等). Environmental Science & Technology(环境科学与技术), 2019, 42(6): 82.
[4] Prathna T C, Sitompul D N, Sharma S K, et al. Desalination and Water Treatment, 2018, 104: 121.
[5] Lata S, Samadder S R. Journal of Environmental Management, 2016, 166: 387.
[6] GUO Ya-qi, YANG Yang, WU Xin-hua, et al(郭亚祺, 杨 洋, 伍新花, 等). Chinese Journal of Environmental Engineering(环境工程学报), 2014，(6): 2485.
[7] Zamorategui A, Ramírez N, Martínez J M, et al. Acta Universitaria, 2016, 26(2): 30.
[8] Chiavola A, Tchieda V K, Amato E D, et al. Chemical Engineering Transactions, 2016, 47: 331.
[9] DING Wen-cheng, YAN Feng-dong, ZHAO Hong-wei, et al(丁文成, 闫凤冬, 赵洪伟, 等). Chinese Journal of Environmental Engineering(环境工程学报), 2013, 7(3): 873.
[10] Dhanasekaran P, Satya Sai P M, Anand Babu C, et al. Water Science and Technology: Water Supply, 2016, 16(1): 115.
[11] Wang Z, Shen X, Jing M, et al. Journal of Alloys and Compounds, 2018，735: 1620.
[12] Chiavola A, D’Amato E, Boni M R. International Journal of Environmental Science and Technology, 2019, 16: 6053.
[13] Kumari S, Khan S. Scientific Reports, 2017, 7(20): 2847.
[14] LI Hui, HE Ting-shu, WANG Yu-bin, et al(李 慧, 何廷树, 王宇斌, 等). Spectroscopy and Spectral Analysis(光谱学与光谱分析), 2018, 38(11): 3588.
[15] MING Xiao-fang, SHANG Xiang-wei, ZHANG Chao, et al(明小芳, 尚祥伟, 张 超, 等). Chinese Journal of Experimental Traditional Medical Fomulae(中国实验方剂学杂志), 2018, 24(20): 89. |
| [1] |
MA Fang1, HUANG An-min2, ZHANG Qiu-hui1*. Discrimination of Four Black Heartwoods Using FTIR Spectroscopy and
Clustering Analysis[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2022, 42(06): 1915-1921. |
| [2] |
ZHANG Dian-kai1, LI Yan-hong1*, ZI Chang-yu1, ZHANG Yuan-qin1, YANG Rong1, TIAN Guo-cai2, ZHAO Wen-bo1. Molecular Structure and Molecular Simulation of Eshan Lignite[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2022, 42(04): 1293-1298. |
| [3] |
WANG Fang-fang1, ZHANG Xiao-dong1, 2*, PING Xiao-duo1, ZHANG Shuo1, LIU Xiao1, 2. Effect of Acidification Pretreatment on the Composition and Structure of Soluble Organic Matter in Coking Coal[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2022, 42(03): 896-903. |
| [4] |
HU Chao-shuai1, XU Yun-liang1, CHU Hong-yu1, CHENG Jun-xia1, GAO Li-juan1, ZHU Ya-ming1, 2*, ZHAO Xue-fei1, 2*. FTIR Analysis of the Correlation Between the Pyrolysis Characteristics and Molecular Structure of Ultrasonic Extraction Derived From Mid-Temperature Pitch[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2022, 42(03): 889-895. |
| [5] |
YANG Jiong1, 2, QIU Zhi-li1, 4*, SUN Bo3, GU Xian-zi5, ZHANG Yue-feng1, GAO Ming-kui3, BAI Dong-zhou1, CHEN Ming-jia1. Nondestructive Testing and Origin Traceability of Serpentine Jade From Dawenkou Culture Based on p-FTIR and p-XRF[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2022, 42(02): 446-453. |
| [6] |
HE Xiong-fei1, 2, HUANG Wei3, TANG Gang3, ZHANG Hao3*. Mechanism Investigation of Cement-Based Permeable Crystalline Waterproof Material Based on Spectral Analysis[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(12): 3909-3914. |
| [7] |
ZHOU Jing1,2, ZHANG Qing-qing1,2, JIANG Jin-guo2, NIE Qian2, BAI Zhong-chen1, 2*. Study on the Rapid Identification of Flavonoids in Chestnut Rose (Rosa Roxburghii Tratt) by FTIR[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(10): 3045-3050. |
| [8] |
Samy M. El-Megharbel*，Moamen S. Refat. In First Time: Synthesis and Spectroscopic Interpretations of Manganese(Ⅱ), Nickel(Ⅱ) and Mercury(Ⅱ) Clidinium Bromide Drug Complexes[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(10): 3316-3320. |
| [9] |
Samy M. El-Megharbel*, Moamen S. Refat. Preparations and Spectroscopic Studies on the Three New Strontium(Ⅱ), Barium(Ⅱ), and Lead(Ⅱ) Carbocysteine Complexes[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(09): 2975-2979. |
| [10] |
WANG Yi1, 2, LI Chang-rong1, 2*, ZHUANG Chang-ling1, 2. Study on Alumina/Lanthanum Oxide X-Ray Diffraction and Raman Spectroscopy[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(08): 2480-2483. |
| [11] |
LI Huan-tong1, 2, CAO Dai-yong3*, ZHANG Wei-guo1, 2, WANG Lu4. XRD and Raman Spectroscopy Characterization of Graphitization Trajectories of High-Rank Coal[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(08): 2491-2498. |
| [12] |
YU Chun-mei, ZHANG Nan, TENG Hai-peng. Investigation of Different Structures of Coals Through FTIR and Raman Techniques[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(07): 2050-2056. |
| [13] |
YE Xu1, QIU Zhi-li1, 2*, CHEN Chao-yang3, ZHANG Yue-feng1. Nondestructive Identification of Mineral Inclusions by Raman Mapping: Micro-Magnetite Inclusions in Iridescent Scapolite as Example[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(07): 2105-2109. |
| [14] |
SUN Feng1, 2, YAN Qing-qing1, WANG Lu1, SUN Zhen-fei1. Study on the Conditions of Hydrothermal Synthesis of Chinese Purple BaCuSi2O6 and the Analysis of Its Products[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(07): 2284-2287. |
| [15] |
QU Li-guo1,2,3, LIU Jian-guo1, XU Liang1*, XU Han-yang1, JIN Ling1, DENG Ya-song1,2, SHEN Xian-chun1, SHU Sheng-quan1,2. Vehicle Exhaust Detection Method Based on Portable FTIR[J]. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2021, 41(06): 1751-1757. |
|
|
|
|
