Study on Simultaneous and Rapid Analysis Method of X-Ray Fluorescence Spectrum for Determination of Chromium, Cadmium and Lead in Water
GAN Ting-ting1, 2, ZHAO Nan-jing1*, YIN Gao-fang1, XIAO Xue1, ZHANG Yu-jun1, ZHANG Wei3, LIU Jian-guo1, LIU Wen-qing1
1. Key Laboratory of Environmental Optics and Technology, Key Laboratory of Optical Monitoring Technology for Environment, Anhui Province, Anhui Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Hefei 230031, China
2. Wanjiang Center for Development of Emerging Industrial Technology, Tongling 244000, China
3. Army Officer Academy of PLA, Hefei 230031, China
Abstract：Coprecipitation method was adopted for simultaneous enrichment Cr, Cd and Pb in water by using sodium hydroxide and sodium sulfide as precipitant. The precipitation homogeneous suspension of Cr(OH)3, Cd(OH)2 and PbS was filtered to prepare uniform Cr, Cd and Pb thin film samples. The energy dispersive XRF spectra of thin film samples were measured in order to realize simultaneous and rapid analysis and determination of Cr, Cd and Pb in water. The influence of reaction time and molar ratio of reactants in the process of enrichment to the XRF spectrum intensity of thin film samples was studied. The precipitation reaction time for 5 min, the best mole ratios of OH- with Cr3+ for 5.0, OH- with Cd2+ for 5.0, and S2- with Pb2+ for 2.0 were the optimum reaction conditions. The homogeneity of thin film samples with different concentrations after enrichment was tested. All the relative standard deviations of fluorescence intensity at six different positions at enrichment area were less than 4.8%, which indicates that all the thin film samples are in good uniformity. The theoretical concentration of thin film samples with different concentrations was compared with measured concentration with ICP-MS method, which confirms that the enrichment rate of this enrichment method for Cr, Cd and Pb in water can reach more than 90%. According to the fluorescence intensity of the thin film samples and the concentration measurements with ICP-MS, the quantitative analysis method of X-ray fluorescence spectrum for Cr, Cd and Pb in water based on the above enrichment was established. The linear correlation coefficients of Cr, Cd and Pb calibration curve were 0.997 3, 0.995 0 and 0.999 8, respectively. When the volume of actually collecting water sample for 50ml, the detection limits of Cr, Cd and Pb were 7.4, 29.6 and 8.5 μg·L-1, respectively. All the detection limits are lower than the maximum allowable emission concentration of Cr, Cd and Pb in (Integrated wastewater discharge standard GB 8978—1996). So this method can realize the simultaneous and rapid analysis and determination of Cr, Cd and Pb in the discharged wastewater of industrial production and life. This study provides a basis for simultaneous and rapid on-line monitoring of a variety of heavy metals in water for X-ray fluorescence spectrometry.
Key words：X-ray fluorescence; Heavy metal; Coprecipitation; Film enrichment; Simultaneous and rapid detection
甘婷婷，赵南京，殷高方，肖 雪，张玉钧，章 炜，刘建国，刘文清. 水体中铬、镉和铅的X射线荧光光谱同时快速分析方法研究[J]. 光谱学与光谱分析, 2017, 37(06): 1912-1918.
GAN Ting-ting, ZHAO Nan-jing, YIN Gao-fang, XIAO Xue, ZHANG Yu-jun, ZHANG Wei, LIU Jian-guo, LIU Wen-qing. Study on Simultaneous and Rapid Analysis Method of X-Ray Fluorescence Spectrum for Determination of Chromium, Cadmium and Lead in Water. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2017, 37(06): 1912-1918.
[1] Zhao Y, Li Z H, Ross A, et al. Spectrochimica Acta Part B, 2015, 112: 6.
[2] Zhang Z, Wang Z, Li Q, et al. Talanta, 2014, 119: 613.
[3] Michael A, Alfred K A, Nafisatu Z, et al. Environ Monit Assess, 2014, 186: 8499.
[4] Shih T T, Hsieh C C, Luo Y T, et al. Analytica Chimica Acta, 2016, 916: 24.
[5] Shih T T, Hsu I H, Chen S N, et al. Analyst, 2015, 140: 600.
[6] Ozcan, Mehmet M, Juhaimi A L, et al. Environmental Monitoring and Assessment, 2012, 184(4): 2372.
[7] Zhao J H, Yan X, Zhou T Y, et al. Journal of Analytical Atomic Spectrometry, 2015, 30: 1920.
[8] Fernanda G L, Medeiros B, Alexandra A P, et al. Reactive and Functional Polymers, 2015, 97: 37.
[9] Ye H J, Liao X F, Guo S L, et al. Advanced Materials Research, 2012, 518-523: 1510.
[10] YE Hua-jun, GUO Sheng-liang, JIANG Xue-jiao, et al(叶华俊, 郭生良, 姜雪娇, 等). Chinese Journal of Scientific Instrument(仪器仪表学报), 2012, 33(5): 1161.
[11] Glen D O, Mark E N, Julie V M. Analytical Chemistry, 2015, 87: 4933.
[12] FANG Zhe, CHEN Ji-wen, HU Shao-cheng, et al(方 哲, 陈吉文, 胡少成, 等). Metallurgical Analysis(冶金分析) , 2016, 36(2): 1.
[13] Antosz F J, Xiang Y, Diaz A J, et al. Journal of Pharmaceutical and Biomedical Analysis, 2012, 62: 17.
[14] Peng Y Z, Huang Y M, Yuan D X, et al. Chinese J Analytical Chemistry, 2012, 40(6): 877.
[15] ZHAI Lei, ZHAN Xiu-chun(翟 磊, 詹秀春). Physical Testing and Chemical Analysis (Part B: Chem. Anal.)( 理化检验-化学分册), 2016, 52(3): 360.
[16] Oscar G F, Eva M, Ignacio Q. Spectrochimica Acta Part B, 2009, 64: 184.
[17] Melquiades F L, Parreira P S, Yabe M J, et al. Talanta, 2007, 73: 121.
[18] Karina K, Beata Z, Rafal S. Spectrochimica Acta Part B, 2012, 73: 79.
[19] DONG Yu-lin(董玉琳). Guizhou Chemical Industry(贵州化工), 2001, 26(3): 32.
