Abstract:A method for the determination of trace silver by flame atomic absorption spectrometry using chitosan enriching method has been investigated. The conditions that influence the adsorption of silver by chitosan were studied. The optimal flow rate of the sample solution was 1 mL·min-1, and the optimal sorption (96.7%) was possible by using the systems with pH 6.0 for silver. The amount of saturated adsorption of silver in the chitosan was 97.8 mg·g-1. Silver was eluted from the chitosan by 1 mol·L-1 H2SO4. 100 mg·mL-1bp>b2+ and Zn2+ did not disturb the determination of silver. K+, Na+, Ca2+, Mg2+ and Mn2+ did not disturb the determination of silver because they were not adsorbed by chitosan. The method has been applied to the determination of silver (1.83 μg·mL-1) in waste water sample with a recovery of 94.3%.
[1] YU Yu-mian, MO Sheng-jin(余煜棉,莫胜钧). Spectroscopy and Spectral Analysis(光谱学与光谱分析),1996,16(3):99. [2] YU Hai-yan et al(于海燕等). J. of Shengyang Institute of Technology(沈阳工业大学学报),1999,21(5):461. [3] HE Hai-cheng(何海成). Spectroscopy and Spectral Analysis(光谱学与光谱分析),1997,17(2):111. [4] LIANG Yong et al(梁 勇等). Chinese J. of Analytical Laboratory(分析试验室). 1999,18(5):41. [5] TANG You-wen et al(汤又文等). Chemical J. of Chinese Universities(高等学校化学学报),1995,16(12):1865. [6] Mo Shengjun, James A Holcombe. Analytical Chemistry, 1990, 62: 1994.