Determination of Glutaraldehyde in Water by Surface Enhanced Raman Spectroscopy Based on Metal Organic Framework Composite Substrate
XU Yang1, LEI Lei2, YAN Jun1*, CHEN Yu-yun1, TAN Xue-cai1, LIU Yu-qian1, WANG Qi3
1. College of Chemistry and Chemical Engineering, Guangxi University for Nationalities, Guangxi Key Laboratory of Food Safety and Pharmaceutical Analytical Chemistry, Guangxi Key Laboratory of Forestry Chemistry and Engineering, Nanning 530006, China
2. Hengxian Comprehensive Inspection and Testing Center, Hengxian 530300, China
3. College of Material Science and Engineering, Kunming University of Science and Technology, Kunming 615000, China
Abstract：The use of glutaraldehyde in the fine chemical industry has resulted in a large number of glutaraldehyde products such as tanners, disinfectants, protein cross linkers, and tissue curing agents being discharged into water bodies, causing serious pollution to aquatic organisms and the eco environment and harm to the whole ecosystem. Therefore, it is essential to develop a rapid and simple detection technique for glutaraldehyde. Surface enhanced Raman spectroscopy (SERS), an established quantitative detection technique based on the scattering effect of light by the molecules to be measured, offers several advantages such as high sensitivity, low amount of sample required, and small water interference, which is highly functional and widely used in the field of analytical detection. The literature has reported no case for the quantitative detection of glutaraldehyde in environmental water bodies based on SERS technology. A surface-enhanced Raman spectroscopy method determining glutaraldehyde in water was developed based on the local surface plasmon resonance effect of gold nanoparticles, the enrichment and concentration of MIL-101(Cr), and the Schiff base reaction between PATP and glutaraldehyde. Au@MIL-101 was prepared by solution immersion method, and then the Au@MIL-101/PATP composite SERS substrate was obtained by modifying PATP on the surface of gold nanoparticles through the Au-S covalent bond. The substrate material is characterized by transmission electron microscope (TEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and Raman spectroscopy. The effect of the density of Au nanoparticles in the composite substrate on the Raman enhancement effect was studied. The Au@MIL-101 material with chloroauric acid concentration at 0.6 g·L-1 has the best enhancement effect. The Schiff base reaction between GA and PATP produces a characteristic peak of C═N at 1 621 cm-1. Good linearity between the ratio value of I1 078 to I1 621 and GA concentration was obtained in the range of 1×10-7~1×10-5 mol·L-1 with the detection limit of 3.5×10-8 mol·L-1. This method is applied to detect glutaraldehyde in river water and tap water. The recovery rates of standard addition in tap water and river water were 91.4%~111.8%, 89.8%~114.2%, and the relative standard deviations were 5.2%~14.5%, 8.6%~13.4%, respectively. This method has the advantages of simplicity, rapidity, and environmentally friendly, which provides a new way for detecting trace glutaraldehyde in water.
Key words：Surface enhanced Raman spectroscopy; MIL-101(Cr); Glutaraldehyde; Schiff base reaction
徐 阳，雷 蕾，严 军，陈裕雲，谭学才，刘玉乾，王 齐. 基于金属有机框架材料复合基底表面增强拉曼光谱测定水中的戊二醛[J]. 光谱学与光谱分析, 2022, 42(01): 115-123.
XU Yang, LEI Lei, YAN Jun, CHEN Yu-yun, TAN Xue-cai, LIU Yu-qian, WANG Qi. Determination of Glutaraldehyde in Water by Surface Enhanced Raman Spectroscopy Based on Metal Organic Framework Composite Substrate. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2022, 42(01): 115-123.
[1] Ministry of Health of the People’s Republic of China/Standardization Administration of the People’s Republic of China(中华人民共和国卫生部/中国国家标准化管理委员会). GB 5749—2006. National Standard of the People’s Republic of China(中华人民共和国国家标准). Standards for Drinking Water Quality(生活饮用水卫生标准)，2006.
[2] Uchiyama S, Sakamoto H, Ohno A, et al. Analyst, 2012, 137(18): 4274.
[3] YIN Hong-lei, DAI Jin-lan, CHEN Xue-can, et al(尹洪雷, 戴金兰, 陈学灿, 等). Journal of Inspection and Quarantine(检验检疫学刊), 2009, 19(1): 65.
[4] Kang H I, Shin H S. Analytical Methods, 2016, 8(15): 3216.
[5] Kang H I, Shin H S. Journal of Chromatography A, 2016, 1448: 115.
[6] HAN Zhi-yu, ZHAN Wei, JIANG Li-na, et al(韩志宇, 詹 未, 蒋黎娜, 等). Chinese Journal of Analysis Laboratory(分析试验室), 2020, 39(2): 240.
[7] Kim H J, Shin H S. Analytica Chimica Acta, 2011, 702(2): 225.
[8] Filenko I A, Golodukhina S V, Usol’tseva L O, et al. Journal of Analytical Chemistry, 2017, 72(9): 977.
[9] Miao K, Zhang H, Sun L, et al. Journal of Materials Chemistry C, 2017, 5(20): 5010.
[10] Tong L, Zhu T, Liu Z. Chemical Society Reviews, 2011, 40(3): 1296.
[11] GUO Xiao-ying, QIU Li, ZHANG Jin-jie, et al(郭小莹, 邱 立, 张进杰, 等). Spectroscopy and Spectral Analysis(光谱学与光谱分析), 2019, 39(8): 2561.
[12] Zhao Y, Zhang Q, Ma L, et al. Nanoscale Advances, 2020, 2(8): 3460.
[13] Ding X, Kong L, Wang J, et al. ACS Applied Materials & Interfaces, 2013, 5(15): 7072.
[14] Lai H, Shang W, Yun Y, et al. Microchimica Acta, 2019, 186(3): 144.
[15] Howarth A J, Liu Y, Peng L, et al. Nature Reviews Materials, 2016, 1(3): 15018.
[16] Sugikawa K, Nagata S, Furukawa Y, et al. Chemistry of Materials, 2013, 25(13): 2565.
[17] Qiao X, Su B, Liu C, et al. Advanced Materials, 2017, 30(5): 1702275.
[18] Sun H, Cong S, Zheng Z, et al. Journal of the American Chemical Society, 2019, 141(2): 870.
[19] Férey G, Mellot-Draznieks C, Serre C, et al. Science, 2005, 309(5743): 2040.
[20] Hu Y, Liao J, Wang D, et al. Analytical Chemistry, 2014, 86(8): 3955.
[21] Zhu H, Du M, Zou M, et al. Dalton Transactions, 2012, 41(34): 10465.
