NIR Quantitative Model Establishment of Cotton-Polyester Blend Fabrics and Related Problem Exploration
SHI Yao1, LI Wen-xia1*, ZHAO Guo-liang1, LI Shu-run2, WANG Hua-ping3, ZHANG Shuo4
1. School of Material Science and Engineering, Beijing Institute of Fashion Technology, Beijing 100029, China
2. Jinghuan Textile Recycling Handan Co., Ltd., Handan 056800, China
3. College of Material Science and Engineering, Donghua University, Shanghai 201620, China
4. Zhejiang Green Environmental Protection Co., Ltd., Shaoxing 312000, China
Abstract：In waste textile recycling, the rapid and accurate determination of fiber type and content is a key part of the recovery program. In this paper, 598 waste cotton-polyester blended fabrics were used as the research object, and the raw near infrared spectra (NIRS) of the samples were tested by portable NIR spectrometer. In the 1 400~1 700 and 1 900~2 200 nm NIR regions, there was a clear difference between the spectra of 100% cotton and 100% polyester samples, and these spectral differences were reflected in the various color fibers. At the same time, the reason why the slant spectrum was produced might be surface effect of the fabric, the coloring method and the fine particles adhered to the fiber surface. Dark samples tended to drift their spectral baselines in the shortwave region. After the derivative pretreatment, the baseline drift was basically eliminated, and the oblique spectrum showed normal spectral characteristics. The quantitative analysis model of waste cotton-polyester blend fabric was established by partial least squares (PLS) method combined with 1st derivative, Savitzky-Golay (S-G) smoothing, mean centering and orthogonal signal correction (OSC) method. In order to verify the reliability of the model, root mean standard error of cross validation (RMSECV) was calculated and 346 external samples were selected to test the model. The RMSECV of the model was 0.002, and the relational coefficient of calibration ( RC ) was 0.998, and the relational coefficient of prediction ( RP ) was 0.997, and the standard error of prediction (SEP) was 1.121, and the prediction accuracy of the model was up to 97%. The error of NIR predictive value and gravimetric determination was within ±3%, and the consistency between the two is more than 90% , while the error was within ±5%, and the consistency was above 95%, and the analysis time of each sample was less than 10 seconds. Therefore, the waste cotton-polyester blend fabric fiber content could be quickly and accurately predicted by using NIR technology combined with the model.
基金资助: the National key Research and Development Program of China “Regenerative Polyester Fiber Efficient Preparation Technology” (2016YFB0302900)，the Beijing Municipal Education Commission Promotion Project (16317) and China Chemical Fiber Industry Association Green Fund project（2016-09）
通讯作者:
李文霞
E-mail: liwenxia307@163.com
作者简介: SHI Yao，（1989—），graduate of Beijing Institute of Fashion and Technology e-mail：sy90129021@126.com
引用本文:
时 瑶，李文霞，赵国樑，李书润，王华平，张 朔. 涤棉混纺织物近红外定量分析模型的建立及相关问题探讨[J]. 光谱学与光谱分析, 2019, 39(02): 634-639.
SHI Yao, LI Wen-xia, ZHAO Guo-liang, LI Shu-run, WANG Hua-ping, ZHANG Shuo. NIR Quantitative Model Establishment of Cotton-Polyester Blend Fabrics and Related Problem Exploration. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2019, 39(02): 634-639.
[1] Xing Shengyuan, Zhou Shuo, Cao Xiaohong. Application Handbook of Textile Fiber and Product Identification. Beijing：Chemical Industry Press, 2016. 20.
[2] Durand A, Devos O, Ruckebusch C, et al. J. Analytica Chimical Acta, 2007, 595(1-2): 72.
[3] Wu G F, He Y. Western Psychologist, 2010, 30(2): 331.
[4] Ruckbusch C, Orhan F, Durand A, et al. Applied Spectroscopy, 2006, 60(5): 539.
[5] Rodgers J, Beck K. Rapid Determination by NIR of the Cotton Content of Blend Fabrics after Dyeing, 2005 Beltwide Cotton Conference, New Orleans, Louisiana, USA，2005.
[6] Geng Xiang, Gui Jiaxiang, Yao Lei，et al. Shanghai Textile Science and Technology, 2013. 25.
[7] Rodgers, James, Beck, et al. Textile Research Journal, 2009，79: 8.
[8] Yan Yanlu, Chen Bin, Zhu Dazhou. Principle, Technology and Application of NIR Spectroscopy. Beijing: China Light Industry Press, 2013, 99.
[9] GB/T2910.11—2009, The Mixture of Cellulose Fibers and Polyester Fibers (Sulfuric Acid Method). National Standards of the People’s Republic of China. National Standards of the People’s Republic of China.
[10] Burns D. Book of Papers, ACS Short Course, New Orleans, La., February 1985.
[11] Perkampus H. Encyclopedia of Spectroscopy. VCH, N.Y., 1995. 387.
[12] Rodgers J. Influences of Carpet and Instrumental Parameters on the Identification of Carpet Face Fibers by NIR, AATCC Rev.，2002，6：27.
