The Effect of Filterson on the Determination of Trace Heavy Metal Cd in Light Matrix by Energy Dispersive X-Ray Fluorescence Spectrometry
ZHANG Li-jiao1,2, LAI Wan-chang1, XIE Bo2, 3, HUANG Jin-chu1, LI Dan1, WANG Guang-xi1, YANG Qiang1, CHEN Xiao-li1
1. College of Nuclear Technology and Automation Engineering, Chengdu University of Technology, Chengdu 610059, China
2. Jiangxi Key Laboratory of Nuclear Resources and Environment, East China University of Technology, Nanchang 330013, China
3. School of Geosciences and Info-Physics, Central South University, Changsha 410083, China
Abstract：Increasing the ratio of peak to back (P/B)value is of great importance when using energy dispersive X-ray fluorescence spectrometry to detect heavy metal elements in the light-matrix. Setting up the filters is one way to solve this problem. In the paper the choices (material elements and thickness) for primary filter(it can be divided into One primary filter and Two primary filter) and secondary filter(balance filter) were analyzed, then the Monte Carlo simulation was carried out by MC software, and the accuracy of theoretical analysis was verified by comparing the P/B value before and after setting up. The One primary filter simulation sets up Fe and Cu two kinds of materials. The results show that the biggest P/B values all increases two times after setting up primary filters while the value is 1.36 before setting up; The Two primary filter simulation sets up Te and Ba two kinds of materials. The biggest P/B values are 14.88 and 13.58, which all significantly increase almost 10 times than the previous setting up; The balance filter sets up Rh and Ru two filters, the balancepassband is obtained through two count subtraction. The results show that in the passband the transmission rate of the characteristic peaks is 83.1%, while outside the band the background value is reduced to almost 0, and the P/B values increase greatly. It is found that setting up the three kinds of filters effectively increases the P/B values, in which the balance filter is the most powerful, the Two primary filter is the second, and the One primary filter is the least. The three kinds of filters can be set up at the same time in order to further increase the P/B value in theory, but the Cd amounts in light matrix are trace, so that the low count result will greatly increase the radioactive statistical fluctuation error, therefore, in the practical application, this point should also be considered to decide whether two filters are set up at the same time, or three are set up at the same time. The innovation of this paper lies in the application of the Two primary filter in addition to the traditional two filters.
Key words：Heavy metal elements；Energy dispersive X ray fluorescence spectrometry；Primary filter；Secondary filter
张丽娇，赖万昌，谢 波，黄进初，李 丹，王广西，杨 强，陈小丽. 滤片对能量色散X射线荧光光谱方法测定轻基体中痕量重金属Cd元素的作用[J]. 光谱学与光谱分析, 2018, 38(06): 1917-1921.
ZHANG Li-jiao, LAI Wan-chang, XIE Bo, HUANG Jin-chu, LI Dan, WANG Guang-xi, YANG Qiang, CHEN Xiao-li. The Effect of Filterson on the Determination of Trace Heavy Metal Cd in Light Matrix by Energy Dispersive X-Ray Fluorescence Spectrometry. SPECTROSCOPY AND SPECTRAL ANALYSIS, 2018, 38(06): 1917-1921.
[1] Nicholas G Paltridge, Lachlan J Palmer, Paul J Milham, et al. Plant Soil, 2012, 361: 251.
[2] Lugendo I, Mohammed N K, Mussa L M, et al. Radioanal Nucl. Chem., 2013, 297: 215.
[3] Muhammad Ali, Tasrina Rabia Choudhury, Babul Hossain, et al. Springer Plus, 2014, 3: 341.
[4] Essa Hariri, Martine I Abboud, Sally Demirdjian, et al. Journal of Food Composition and Analysis, 2015, 42: 91.
[5] Keshav Krishna A, Tarun C Khanna, Rama Mohan K. Spectrochimica Acta Part B: Atomic Spectroscopy, 2016, 122(8): 165.
[6] Tom Schoonjans, Vicente Armando Solé, Laszlo Vincze, et al. Spectrochimica Acta Part B, 2013, 82(4): 36.
[7] XIE Xi-cheng, LAI Wan-chang, LI Jun, et al(谢希成, 赖万昌, 李 军, 等). Nuclear Electronics & Detection Technology(核电子学与探测技术), 2014, 34(6): 689.
[8] Conrey R M, Goodman-Elgar M, Bettencourt N, et al. Geochemistry: Exploration, Environment, Analysis, 2014, 14(3): 291.
[9] Trevor J Morgan, Anthe George, Aikaterini K Boulamanti, et al. Energy Fuels, 2015, 29(3): 1669.
[10] Ryota Yagi, Kouichi Tsuji. X-Ray Spectrometry, 2015, 44(3): 186.
[11] Li Xiaoli, Yu Zhaoshui. Applied Radiation and Isotopes, 2016, 111(5): 45.
[12] David Hradil, Petr Bezdika, Janka Hradilová, et al. Microchemical Journal, 2016, 125(3): 10.
[13] Ryan J G, Shervais J W, Li Y, et al. Chemical Geology, 2017, 451(2): 55.
