1. School of Mechanical Engineering, Hebei University of Technology, Tianjin 300401, China
2. School of Energy Power and Mechanical Engineering, North China Electric Power University, Baoding 071003, China
Abstract：Differential Optical Absorption Spectroscopy (DOAS) can be used to achieve online monitoring of polluted gas. To improve the monitoring accuracy, the Fourier Transform Filtering Method (FFT) is usually used to process differential absorption spectral data. However, due to the limitation of frequency resolution, its amplitude accuracy is affected, which leads to a large inversion error of gas concentration. A spectral data processing method that combining FFT and FT (FFT+FT) is proposed. First, the panoramic spectrum of differential absorption spectrum data is obtained by FFT filtering，then the spectrum near the peak point is refined by using the improved continuous FT, which can improve the resolution of the characteristic absorption frequency band, the amplitude error is compensated, and the accuracy of gas concentration on-line monitoring is improved. Many SO2 and NO2 gases with different concentrations were measured. When the zoom multiple is 15, the maximum measurement error of SO2 and NO2 gas is not greater than 3.68% and 3.17%. Compared with the FFT method, the average error decreases by 1.82% and 1.45%, respectively. Compared with the traditional polynomial fitting method, the average error is reduced by 14.9% and 1.80%, respectively. SO2 and NO2 gas with the same concentration were measured many times, which verified the stability of the algorithm. The influence of the zoom multiple on the measurement accuracy is analyzed. When the zoom multiple is less than 15, the concentration inversion error decreases with the increase of the zoom multiple. When the refinement multiple increases from 15 to 20, the error increases gradually. When the refining multiple is greater than 20, the errors fluctuate, and all of them are greater than the measurement errors when the multiple is 15. This is because the spectrum lines are too dense due to the large refinement multiples, and the probability of finding the maximum value of the spectrum sequence is reduced. Therefore, when the spectrum with noise is corrected by this method, the measurement accuracy will decrease with the increase of zoom multiple. To reduce the calculation amount of frequency spectrum zooming, the optimal zoom multiple is determined, which satisfies the requirements of measurement accuracy and meets the requirements of DOAS method for real-time online monitoring of pollution gas.
Key words：Differential optical absorption spectroscopy; Spectrum zoom; Fast Fourier transformation and fourer transformation
[1] Al-Jalal Al，Watheq Al-Basheer W，Gasmi K，et al. Measurement，2019，(146)：613.
[2] Casaballe N，Di Martino M，Osorio M. Applied Optic，2020，59(13)：179.
[3] Wang Lin，Zhang Yungang，Zhou Xue，et al. Sensors & Actuators, B: Chemical，2017，241(3)：146.
[4] ZHOU Hong，XIAO Song，ZHANG Xiao-xing，et al(周 红，肖 淞，张晓星，等). Proceedings of the CSEE(中国电机工程学报)，2017，37(19)：5812.
[5] YU Min-jie，LIU Ming-hui，DONG Zuo-ren，et al(郁敏捷，刘铭晖，董作人，等). Chinese Journal of Lasers(中国激光)，2015，42(9)：351.
[6] MA Ke，ZHANG Yuan-an，ZHANG Kai-sheng(马 可，张远安，张开生). Computer Measurement & Control(计算机测量与控制)，2016，24(2)：288.
[7] YANG Hui-yue，TU Ya-qing，ZHANG Hai-tao，et al(杨辉跃，涂亚庆，张海涛，等). Application Research of Computers(计算机应用研究)，2015，32(6)：1608.
[8] Cui Z L，Zhang X X，Cheng Z，et al. Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy，2019，(215)：187.
[9] Jiufei L，Zhijiang X，Ming X. Mechanical Systems and Signal Processing，2016，（70-71）：1011.
[10] XIAO Hong，YANG Yong，XIE Ming，et al（萧 红，杨 勇，谢 明，等）. Journal of Chongqing University（重庆大学学报），2017，40(8)：27.
[11] Specifications and Test Procedures for Continuous Emission Monitoring System in Flue Gas Emitted From Stationary Sources(固定污染源烟气排放连续监测系统技术要求及检测方法). Beijing：China Environmental Publishing Group(北京：中国环境出版集团)，2017，8.
